|
|
|
|
Catalyst Control Console Screen shots Power-up screen Post power-up screen, waiting for Security Key Main Menu Configuration screen Sequence Load screen Charging the Firing Modules Charging the Firing Modules Search begins to discover Firing Modules connected... Found two Firing Modules... repeat search Found 13 FM's on this trip, repeat until two consequtive trips find same number of FM's Found 23, try again... Found 26 FM's, try again... Found 26 a second time. All FM's charged and ready! Main Firing menu, FM's in CHARGED, but SAFE mode. CUE Check screen, FM's in SAFE mode. CUE Check screen, FM's in SAFE mode. Warning Screen from main fire menu when selecting Direct Fire mode DIRECT FIRE mode screen GROUP FIRE Mode Sequence Mode... loading sequence to FM units Sequence Mode, loading continues... Sequence Mode, verifying after download has completed. Sequence Mode, verifying after download has completed. FM status checked for each REQUIRED Firing Module FM status checked for each REQUIRED Firing Module FM checking continues on FM-02 Continue Sequence checking for FM-02 FM unit checking continues FM unit sequence checking continues Sequence Check continues Sequence Mode Security Key needed Main Sequence Screen Sequence countdown started Sequence halted due to Deadman switch not pressed Shell Timing opening screen Shell Timing screen Shell Timing Screen Shell Timing screen Shell Timing screen Shell Timing screen Sets display brightness, work-light brightness, etc Allows sequence to be loaded either from the SD-card or the computer data-port (RS232) Progress bar at the bottom of the screen shows where in the charge phase the console is. First 50% is static charging (approx 30 seconds) Still charging... FM #01, has single cue attached on CUE-01 FM#14 has all 32 cues with an ematch attached. Requires the Security Key to enter this state (ARM) FM-01 showing one CUE (#01) available to fire Shows the number of CUES contained in FM-00 through FM-09, FM-10 through FM-19 and FM-20 through FM29. Screen #1 of Sequence Verify on FM unit 01 Screen #2 on FM-01: Shows one good CUE (#01) and the rest are missing CUES required for the sequence. Screen #2 on FM-01: Shows one good CUE (#02) and the rest are missing CUES required for the sequence. Screen #2 on FM-14: Shows 30 good CUEs (#01 through #30) and the rest are CUES that show attached ematches that are NOT required for the sequence. FM-18 shows a good CUE on #18, but many missing. CUEs #31 and #32 show no attached ematches and also indicate that they are NOT required for the sequence. Screen #1 from Sequence check showing that FM-99 is not present at all. After FM unit verification, one more touch of the Security/Safety Key is needed in order to advance into the screen that controls starting the show sequence (ARM). Bottom of screen shows progress bar where show is currently. Allows you to continue from the stop point or abort show entirely. Will first gather reaction times from Operator Operator presses Deadman switch to single shell effect was seen. Ready to collect shell timings, explaination screen Shell #01 fired, waiting for Operator to signal effect has been seen. Operator has signaled effect was seen All shell timings have been completed, screen gives instructions on how to store data in SD-card.
Power-up screen |
|
Send mail to Catalyst-Pyro@BizzyBitz.com with questions or comments about
this web site.
|
